Even for a novice do-it-yourselfer, installing a mortarless flagstone path is a practically foolproof project. “It’s not very technical and doesn’t require any power tools,” says Tom Piergrossi, nursery owner, garden designer and host of “Down to Earth,” a gardening show produced by the San Diego County Television Network. “It’s mostly labor, but there’s enough artistry involved to make the task satisfying.”
Piergrossi and his crew built the path shown here at the home of Rich and Holly Mayes in Escondido, Calif. It replaced a narrow concrete sidewalk that led straight to the front door.
The new path is wider and takes a few curves, forming generous planting pockets along the way.
There’s just enough space between the stones for strips of ground cover to grow.
Piergrossi used Mazus reptans, a Himalayan native. Other candidates include baby’s tears, dwarf thyme and Irish moss.
Design: Tom Piergrossi Landscape and Nursery, Vista, Calif., 760-598-4882
Tools
- Spade
- Rake
- Hand tamper (available at rental yards)
- Two stakes, string, line level
- One or two two-by-fours, at least 6 feet long, to use as leveling guides
- Stone or brick chisel
- Safety goggles
Materials
- Gypsum or flour
- Decomposed granite (sold by the cubic yard; 1 cubic yard, about $24, covers 160 square feet to a depth of 2 inches)
- Compost
- Flagstone of regular thickness, about 1.5 to 2.5 inches thick (slabs are sold by weight; 1 ton, about $320, covers 100 to 120 square feet)
- Ground cover (sold in nursery cell-packs or mud flats)
Directions
- Outline the edges of the path with gypsum or flour. Measure the surface area of the path, then estimate the amount of decomposed granite, compost and flagstone you’ll need to buy.
- Use a spade to excavate the soil between the lines to a depth of 4 inches; rake to smooth surface.
- Spread a 2-inch layer of decomposed granite over the area; firm down evenly with a hand tamper.
- To ensure that the path follows your lot’s grade (essential for proper drainage), place stakes at each end, tie a string at paving-stone height between them, and attach a line level to the string.
- Atop the decomposed granite, place pairs of flagstone slabs to act as guide stones; lay the flat side of a two-by-four on top of the slabs at the level of the string. Between these guide stones, arrange more flagstone pieces, using the two-by-four to keep an even level. Use a chisel to break pieces to desired shapes (wear safety goggles), but don’t make them too uniform — you want a rustic look. Allow a gap of 0.5 to 1 inch between pieces for planting seams.
- After placing all stones, estimate in linear feet the amount of ground cover you’ll need to fill the gaps. Then plant plugs from cell-packs or strips cut from mud flats; fill gaps with a mix of decomposed granite and compost. Water thoroughly.
By Sharon Cohoon, Sunset
